Polymers Made to Work Hard By The Maritime ... Vesconite manufactures low-friction, long-lived polymers that are ideal for a wide range of marine applications, from deck gear to stern and rudder ...Vesconite is suitable for continuous use at 100º - 120°C (212º - 248°F) in dry conditions and 60° - 70°C (140° - 158°F) in wet conditions. Shaft friendly. With Vesconite, the wear rate of corresponding metal pins and shafts can be reduced by as much as 90%.Overview of Bearing & Wear — Bearing and wear-resistant plastics materials such as Delrin®, Nylon®, Vespel®, Meldin®, Acetron®, Torlon®, Turcite®, Rulon®, UHMW, Fluorosint ®, and Tivar® are available from Professional Plastics.

A traditional metal mechanical fastening can also be used if preferred. Can UHMW be formed into a curved liner? Bending or folding sheet can be done efficiently above the melt point at 300 degrees F. At that temperature, it shapes easily. However, it must be fastened in the bent or folded position until cooled. How thick should UHMW liners be? A traditional metal mechanical fastening can also be used if preferred. Can UHMW be formed into a curved liner? Bending or folding sheet can be done efficiently above the melt point at 300 degrees F. At that temperature, it shapes easily. However, it must be fastened in the bent or folded position until cooled. How thick should UHMW liners be?